|
Viewing Performance and Tune Up >> Brakes and Suspension >> Suspension Tools and Accessories Wheel Alignment Gauge
Now you can check wheel alignment in minutes. Tool measures toe-in and toe-out on an easy to read gauge. Lets you adjust alignment to minimize tire wear. Even checks wheel wobble. To use, set gauge at rear of front tires and take measurements. Transfer tool to front and measure the difference. If necessary, adjust tie rods in or out half the distance of the dial reading.
6 Piece Double Duty Wheel Socket Set
Remove standard and damaged lug nuts with the same 1/2" drive impact socket set to save both time and money. One end is a standard 6-point impact socket, and when flipped around it becomes a 6-flute "twistsocket" to remove damaged lug nuts. Kit contains 5 impact sockets 14mm, 19mm, 3/4", 21mm, 13/16" and 7/8" plus a 3" impact extension in a molded case. Made in the USA.
Coilspring Compressor Internal
The Internal Coilspring Compressor quickly compresses coil springs for easy removal and replacement. Makes installing coil spring spacers easier, safer. Also compresses springs that are perfectly straight or slightly curved. For most passenger cars, pickup trucks. Instructions included. Made in the USA.
Tie Rod Puller
If you are only removing the tie rod end from the steering arm, not replacing it, you want to protect the rod end. This Tie Rod Puller grips the steering arm and pushes the tie rod end stud through the hole, releasing it without hammering or damage. Made of forged steel. The larger (49060) Front End Service Kit includes a similar tool plus more.
Bearing Race And Seal Driver
When installing seals and bearing races, it is critical to drive them in correctly. If not driven in perfectly square, seals could leak and bearings can fail prematurely. Includes six easily changed discs and an aluminum drive handle. Use the flat side of the discs to drive seals, use the tapered side to drive races.
Bushing Driver Set
Use this Driver Set to remove or install "internal" bushings and bearings. 16 adapters and three driver shafts which will service jobs with 7/16" to 1 3/8" O.D. and 3/8" to 1 1/4" I.D.
Tube Chassis Inline Coupling-1 1/2in
These elegant tubing solutions join chassis tubing sections where a section needs to be a removable component. Machined from 4130 Chrome Moly stock, these connectors are stepped to fit the specific tubing size. Just weld onto the tubing form a pleasing smooth transition. Center is "Z" cut and cross-fastened with socket head cap screws for precise alignment and exceptional strength.
|